Posted by stormchaser12 on May 24, 2011 at 14:06:59 from (99.197.217.205):
Just installed my professionally rebuilt head on my 630 LP. Got it all bolted up and torqued to 150lbs on the head nuts. All New Gaskets everywhere. Every LP component was rebuilt before I got it, Its getting fuel to the strainer, and I can hear the "click" when I turn the key on. Air Cleaner oil bath is full of new oil to the correct level. Problem, I turn the tractor over on its own power, but it has no compression at all. It turns over like a bat out of down south, but absolutely no compression. The head was redone by the best cylinder head place in the usa so I cant imagine the head would be the issue. I took the valve cover off and turned it over and none of the valves are stuck.
Why am I not getting compression? Its getting spark to the plugs.
This is my first LP and I thought I knew a fair amount about them, but what am I missing or doing wrong?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.