We"ve been using it for years. Hardi and now the Certainteed product (better pricing). My thoughts:
1. If you"re going to re-side your house, either go vinyl/aluminum or go fiber cement (Hardi). Wood siding can be a long lasting product but wood will require more frequent maintenance and requires very very good prep to get it right.
2. I can"t really recommend the pre-painted fiber cement products. Every time we have used them, we end up giving the exterior at least one coat to make it look right. Then the savings go away.
3. You will eventually need to repaint and the frequency will depend on many factors such as exposure, your location in the world, type of paint used, etc. The buzz used to be it would hold paint for 10 years - I tell clients expect 8 (here in the midwest), maybe less on the south side, more on the north side.
4. It is probably the closest to replicating a smooth redwood siding - and that"s where we use it a lot. Almost exclusively use the smooth product. Just not a fan of the fake wood grain. Their simulated shake siding and stucco look panels do a decent job visually.
5. If you have carpentry or trim carpentry experience and knowledge of weatherization/flashing techniques, you can probably do a decent job if you read up on it - and get the right tools. Wrong tools and you spend the day looking like Casper the Ghost.
6. We rarely use the Hardi trim boards. usually go with primed cedar or redwood (if we can get it). Just haven"t been happy with the workability of their trim boards and the cost is a bit more.
Overall, it"s my first siding choice if the client has the budget.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.