Posted by s.crum on May 29, 2011 at 05:20:45 from (12.75.110.65):
Over the years I've heard and seen some pretty amazing thinking that ranges from truely great to completely stupid (done a few of each myself). Two of the aspects of this that amaze and amuse me at the same time are the "That's the way it's supposed to be" and "that's the way we've always done it" factors. A good example that came to mind just this morning, is the location of the roll of toilet paper in the big bathroom. For the past 25 years I've lived here this has been my bathroom of choice. As such I tend to form things to my liking rather than conform to a "set of rules". Anyhow the contractor that built this house saw fit to locate the toilet paper roll on the wall that is behind the john which for me anyway is somewhat awkward, so I've always left the roll of paper on the corner of the vanity for easy access. Former wife seemed to have a 'simmering' problem with this. She finally one day stated "that's not where it's "supposed to be". Ok then, was it a perticular law that the contractor followed that put that roll where "it's supposed to be"? Or did he locate it there because it was convenient, cheap and easy for him to locate it there? Even though I've had to live with this decision for the past 25 years. I guess my question is how many day to day things can be done quicker, easier, more efficently and even cheaper if we were not to accept the thought that "it's supposed to be that way" and "we've always done it that way"? Granted many things are the way they are because that's the way they "gotta' be" whether by law or emminent destruction otherwise. So what is your "supposed to be like that" thought?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.