Posted by RMinVa on May 29, 2011 at 11:11:51 from (67.142.166.23):
In Reply to: JD 720 Mo/Co questions posted by NewEnglandFarmer on May 29, 2011 at 05:56:26:
I have a 820 with non clog guards. Have to use a feeler gauge to get the proper cut. If you see a jack bolt on top so you can add pressure to the sections then use the feeler gauge to set each one.(5 -8 thousands) I set mine at 8. Also check for proper tension on the belt that drives the wobble box. I've had to tighten mine several times over the past 10 years. If it slips it'll clog the cutter bar. With proper set non clog guards those machines will cut very thick and even down crop easy. With non clog guards you won't have to sharpen. They self sharpen. I know nothing about the regular guard type for JD Moco's. Always use non clog guards.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.