Posted by The tractor vet on June 08, 2011 at 18:20:32 from (76.212.230.69):
In Reply to: IH 1066 PTO problems posted by doug in illinois on June 08, 2011 at 18:04:25:
To swap out the PTO clutch pac all ya need to do is get the PTO out and on a flat surface and a screw driver . Now if you are going to go deeper then ya need to compress the springs to get to the Orings on the piston and if your going deeper then ya need a piston ring compressor for the teflon seals . also you should have the test fitting to go into the pressure test port so you can check and set the lock up pressure once you have it back in the tractor to make sure that you have proper loc up on the clutches. and a gauge that will read 600 lbs.. Myself i like to set the loc up at 260-270 on a 1066 as i am sure that she ain't setting stock.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.