Posted by j heikemper on June 22, 2011 at 20:31:02 from (184.9.229.82):
In Reply to: OT: It's Raining! posted by CLTX on June 22, 2011 at 11:04:02:
yeah, glad you finally got watered , if I were God i would fix it so everyone got a nominal amount ..LOL, it is pourin here in louisville area , ..at 5 pm started cutting hay , no rain on the horizon accoding weatherfolx ,, started misting around 6 , picked up more and more , so i quit , looked a little nasty on the way home .. kept watching a funnel cloud but did not think it was for REAL, thought not much more than a low hangin oddesy ,, tornado hit town of elizabeth , 2 miles south of here ,, watched another funnel cloud form serveral miles out, called 911, and reported it and watched it roll andtwist directly above my house, way up hi ,, these storms went into louisville and really caused some damage,, we had another 3 +of rain tonite , we had a terribly wet spring that all of a sudden dried up and got hot and baked the ground hard... up until ,2 weeks ago we were so dry the corn was rolling up and the cows were working on turning the pastues into a desert , got a 3 inch rain , i put triple 19 on pastures .. bet we have had 10 inches rain in last 10 days ... sure is a strange year ,,normal weather her e is nothin like any of the previous 10 yrs ...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
