Posted by tjdub on June 23, 2011 at 20:56:17 from (208.74.246.137):
In Reply to: Just because...... posted by oldtanker on June 23, 2011 at 12:55:34:
Make sure it has 85HP or more, dual hydraulic remotes, and the ability to run 1000 or 540rpm PTO. That will really keep the options open for haying equipment. If you only have one tractor though, you will want to buy all implements in one PTO speed anyway though.
I like my JD 2950 (1984) and my JD 4020 (1970). I could do all my haying with either one of them. I prefer using the 2950 though, mostly because of the higher hitch and more comfortable controls. The 2950 is MFWD which causes problems sometimes when baling because the drive shaft for the front axle picks up hay sometimes. On the other hand having MFWD really helps when mowing on steep hills and it's a lot safer taking loads of bales down hills.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
