Posted by Bob Bancroft on June 25, 2011 at 04:52:27 from (97.73.64.154):
In Reply to: PTO adaptors posted by novacane on June 25, 2011 at 02:02:51:
Is there such a thing as 1 3/4" 6 spline? My CaseIH 7240 has a large, 1000 RPM shaft only. I think it's 20 spline? I have adaptors that I use on it to run a 540 RPM (1 3/8" 6 spline) bush hog. I say adaptors because the first one has a slight twist in it. Even at 11-1200 engine RPM apparently there's enough torque to do damage. When I went to get another adaptor I heard the same story twice- LAWSUIT- good luck getting an adaptor! So I ordered one from two different places. They both eventually showed up! With my drawbar lengthened WAY out it's just far enough with the added PTO length on there. Be careful!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
