Top link centered with NO angle. Depth guage wheel on plow, Right wheel slid in far enough you think the tractor is going to roll to right. On that plow the proper draft setting would be from center of drawbar to inside sidewall of tire 17 1/2" and that would not be possible as that would make a wheal tread of 45" and typicall the narrowest tread setting would be 62" with that being on the rollover danger side. If you are only trying to plow 6" deep not as dangerous as trying to plow 8-9" deep. Most 3 bottom mounted plows would take those same measurements. A 16" plow would take those same measurements. A 3-14" plow would be 24 1/2" from center to inside furrow wall of tractor and make a 58"-60" wheel tread and that would still work but still not be as safe as a 66-68' wheal tread is. That small plow DO NOT run the furrow wheel on the low side as downhill side while plowing unless you have a good ROPS.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.