Posted by Buzzman72 on July 07, 2011 at 07:51:52 from (74.129.195.67):
At the garage, my grand-dad had a knife grinder for sickle mower knives...it had a spindle with a V-shaped stone, a foot-operated clamp for the knife, and the spindle with the stone was belt driven by an electric motor. The spindle was spring-mounted with a handle, so you could manually control the pressure of the stone agains the knife. The whole apparatus was about 4 feet long, the frame made of angle iron, and it worked best if you could sit on a shop stool...although operating it in a standing position was also possible.
Would this have any value today, other than scrap value? I mean, in an era of disc mowers and such, it's more of a curiosity piece.
Grand-dad also had a lever fixture that fit in a vise, and allowed you to compress the rivets in a a mower knife section two at a time. It was about a 2-man operation,since one had to hold the knife while the other operated the lever, but when two were involved it was a lot quicker than hammering the rivets with the old floor fixture and a concave punch.
Any value to that one? Or would they be of value if perhaps sold as a set?
Or do I just have some genuine antique scrap iron here?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
