Posted by Mel in SW Iowa on July 07, 2011 at 11:56:21 from (75.105.60.128):
In Reply to: O.T. for Gun Guru posted by JerryS on July 06, 2011 at 20:34:07:
JerryS, Reading your description of the malfunction you experienced, it sounds like you experienced a failure to extract. It should have been accompanied with a noticeable decrease in recoil and/or noise level. Failure to extract in a 1911 can be caused by a "squib" or low powered round that doesn't create enough chamber pressure to push the slide back far enough for the shell casing to be struck by the ejector. Failure to extract can also be caused by too strong a mainspring, but this will cause all rounds to fail to extract. Your experience is most probably due to one low powered round in the ammo you are using. A "stovepipe" is a term used to describe a failure to feed. It is most often caused by magazine feed lip improperly shaped, occasionally caused by a rough or damaged surface on the feed ramp, weakened/aged magazine spring or damaged follower.
I have never used "Wolf" brand steel cased ammo in a 1911, so I don't know if there are problems there.
Springfield Armory has a very good reputation among people who shoot a lot.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
