The height is usually about 3-4 foot above ground. The amount buried is different according to how cold you get in the winters. Here in North east Iowa I go 4 foot minimum and 5 foot will never freeze. Sometimes we hit limestone bed rock so we have trouble getting them a full five foot.
As others have stated use a good fitting at the bottom. I have been using brass the last four or five years. Had a galvanized one rust through in just a few years. Never use plastic they will break.
I always put a couple of five gallon buckets of clean washed stone at the bottom of them. That way they can always drain the mast out. If you don"t have any clean gravel handy I have picked up the bags of decorative stuff at a garden center. Better than having a whole load hauled.
NOW I differ from some of the others here on whiter to cement around the top. I did not used to do it. Then I had two break the fittings off the bottom in January. I got to watching the hydrant mast as you turn them on and off. If you do not cement them they will move when you turn them on and off. It is just a little but remember the fitting on the bottom is covered up and anchored solid. Any movement will break the fitting over time. So I now cement around them. What I do is make a two foot square form out of 2 x 4 lumber. A single bag of Sackrete will just about fill it. I use the concrete mix and add about two shovels of extra sand. This will make the cement just a little weaker. If you ever have to work on the hydrant you can break the weakened cement easy with a sledge hammer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.