Posted by LonM on July 22, 2011 at 14:33:06 from (69.165.30.214):
Bob- After reading your reply regarding the F-10 loader plumbing, I took a closer look, and sure enough, there is only one line that feeds pressure oil to the valves (I thought there were two, but the other one is the pressure/return for the big one-way lift cylinders). So I may have misled you somewhat, but the pressure line does go in the rear of the grapple/push-off valve, and that must feed the main control valve as well (recall I mentioned the line coming out of the front of the grapple/push-off goes in the front of the main valve). So the line having the Y-shaped relief valve feeds the grapple valve first and then the main gets its oil from the grapple valve. Probably clear as mud, but I wanted to attempt a correction message to redeem myself a little. Hope this hasn't ruined anything for you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
