Posted by dave2 on August 04, 2011 at 04:59:38 from (79.240.150.6):
In Reply to: hey dave 2 posted by rusted nuts on August 04, 2011 at 03:47:36:
rusted nuts said: (quoted from post at 03:47:36 08/04/11) have you read my last answer to your post from yesterday bout sending the hydrant in two boxs? another thing if you or someone else is going to cut the stem in 1/2 and then thread the ends to put it back together then you should used a sucker rod coulper, all it is a nut but it's bout 2" long with bout a 1" of threads in each end can get them with 3/8, 1/2" 7/16. threads don't cost much round here.
Thanks....
Gonna have my buddy go measure one and see if it can be shipped as/is, if not, I'll either take Brad up on his offer or spring for one here..
This post was edited by dave2 at 05:09:06 08/04/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
