Posted by nickg on August 09, 2011 at 07:46:32 from (96.27.152.195):
In Reply to: Hay making Screw-UP!!! posted by Gilbert in IL. on August 08, 2011 at 20:52:19:
I ues to do a fair bit of custom work. Not to much anymore. Just not as much time to do as much. Any way the man did the job. YOu didnt get what you wanted and that can be upsetting.Before you get to twisted about it you should talk to the man and see what happened. If he is not willing to work something out do to his mess up then Id look else where.But you still owe the man for his services. If I were him, and Ive had this happen to me before, is if you didnt pay then those bails would become mine for payment. Sounds to me like you just need to talk to him. If your that unsatisfied just sit down and figure what it will cost you to buy all the stuff you need to bail yourself versus havin custom work done cause then if theres a screw up you can only be mad at yourself.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
