Posted by John T on August 27, 2011 at 06:22:08 from (63.252.228.254):
In Reply to: OT wire question posted by DanR on August 27, 2011 at 05:18:00:
Of course direct bury UF is easy, just dig a trench n bury the cable. HOWEVER I'm like Mark, if you bury conduit then snake the cable (USE or THWN, I forget????) through youre better protected and can upgrade sooooooo much easier. I wouldnt run any less then 100 amps of service (No 1 copper should allow for voltage drop) or at least use big enought conduit and wire so that much could be supplied if and when needeed. Id use rigid conduit risers where the underground conduit rises up above the ground (or under driveways) and LB's into your building.
For 120/240 volt single phase 3 wire serive, run 2 Hots (L1 & L2),,,,,1 Neutral (a GrounDED conductor),,,,,,,1 Equipment GroundING conductor) and at the remote buildings panel DO NOTTTTTTTTTTT bond the Neutral and Equipment Ground Busses together (keep isolated i.e. need a panel that allows for such) like is done at the main service entrance. Of course each buildings service still requires adequate earth grounding such as made grounding electrodes like driven copper rod or rods or metallic water pipe etc etc.
Its not that bad of a job to bury plastic pipe and the wire wont be much more expensvive then Underground Feeder UF and with 100 amp rated conductors or bigger to allow for voltage drop (if youre not going over 100) then youre set for life
Leavin Half Century of Progress in Ilinois headed for Ohio today
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
