Okay, assuming all is working correctly?? Shes tripping cuz theres a leakage of current, EITHER AT THE GFCI OR DOWNSTREAM FROM WHATS FED OFF ITS LOAD SIDE, of current coming out on the HOT but NOT being returned by the NEUTRAL i.e. theres a ground fault somewhere and it only takes like 5 milliamps to cause the trip.
Id start by rewiring such that lights or whats NOT required to be GFCI protected is NOT fed off the LOAD side of the first GFCI in the circuit i.e. feed the light circuit from the HOT supply side circuit that serves the GFCI instead of them being fed from the GFCI"s load side.
However, receptacles by the kitchen sink etc must still be GFCI protected, so other downstream receptcles on that same circuit are still fed off the GFCI load side or are more individual GFCI outlets.
Id suspect EITHER a bad GFCI (its relatively cheap n easy to replace, but you already tried that) or else a ground fault on the LOAD side which may be on that lighting circuit
YOU REALLY NEED TO FEED THOSE LIGHTS NOTTTTTTTTT FROM THE GFCI LOAD SIDE Id try that and/or a new GFCI first as thats not expensive or hard or rocket science to accomplish.....
Sure bad connectiosn can cause all sorts of weird things buttttttttttt a "working properly wired" GFCI TRIPS MOSTLY DUE TO LEAKAGE CURRENT INSTEAD OF BAD CONNECTIONS so Id look there first especially where it feeds the lights and light switch
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
