Posted by Tech 7 on September 23, 2011 at 07:57:58 from (206.47.90.66):
Posted this on the Case forum a few days back but didn't get any response so here I am; have rolled the engine to #1 TDC compression,mark on flywheel is visible through plug hole in bell housing,turned mag until it snaps at #1. This is a Case mag I believe and has a pointer indicating which tower is being fired. Then bolted mag in place and towed.It will fire,late I think as we can get flame out the exhaust when I tweak the run/start lever on the back of the mag.I narrowed the points up a bit but this did not change anything. Went through the above steps several times,including hand cranking and watching the valves/spark relationship which appears close. Finally called it a day shortly after mid night and drove home (an hours drive) so don't feel to brilliant today. Any help with this issue (the tractor,not me!) would be appreciated, Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.