Posted by Owen Aaland on September 24, 2011 at 17:15:14 from (216.47.32.147):
In Reply to: 706 clutch posted by Kevin Roberts on September 24, 2011 at 15:10:10:
The classic example of what happens with a worn out MCV pump and a TA that has a worn out sprag clutch in the low side of the TA.
The MCV pump provides oil for the steering, brakes, TA, and TA and transmission lube, in that order. With no demand on the steering the oil just flows through and the pressure is regulated by the pressure regulator valve in the MCV to about 250 PSI. When the steering is put on demand the pressure rises until the tractor steers or it open the steering relief valve at 1800 - 2100 PSI. In a worn out pump the flow drops off as the pressure increases. When the flow drops off the TA no longer has pressure to keep the clutches engaged and so they release. If the sprag was good on the low side the tractor would down shift to the TA speed but keep pulling. Because it stops we can determine that the sprag is slipping. When the pressure requirements for the steering drop off the TA again receives oil and the clutches engage again with a bang.
When you pull the MCV off the center section you may find a blown O-ring or it is possible that the flow divider valve is stuck but those conditions can be seen after things are apart. If other problems are found it is possible that the pump may be OK.
A bigger problem can not be seen when you have these conditions. The excess flow from the MCV pump is used to lubricate the range transmission and differential bearings. Since the steering has priority if you do not have enough pressure to satisfy the steering there is no lube flow through the oil cooler and the rear frame.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.