Posted by luv2wrench on September 27, 2011 at 11:01:51 from (216.170.42.241):
What is going on with todays new job force?? I work as a GM mechanic in a shop in the Midwest And have been doing so for 12 years as I just turned 30. I m not old by anymeans, but these new guys in the shop don"t respect tools, time or older (experienced) mechanics. When I was starting out, I busted my butt around older techs learning as much as i could. I always brought back tools i barrowed cleaner than when i barrowed them and made a point to buy that tool. When a older tech yelled at me, I took it constructively and tryed to learn from it, and I did. These new guys don"t know how to work. Are we babying our youthful work force too much?? I think so. I learned my work ethic from my grandpa. "Show up early, stay if needed, and if your gonna take the time to do it, do it right and with pride, your name is on that repair when your finished."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.