in the pictures ,and if i figure correctly that its no 2 thats giving you problems(third from left looking forward?) it sure appears to me the share has no suction,its worn.on one and three notice how the point seems to be curved on bottom?i dont see that on two.,at least looking at the pictures.if so and that is really straight instead of curved thats quite likely your problem.also check the FROG thats the part holding the bottom parts together thats bolted to the beam.check and see if there are spacers washers or things on the others that are missing there.Measure from point to point on the working beams.in two or three places and see if your beam is twisted.if so you MIGHT be able to turn bottom back by adding spacers on the frog to line it up.i would check that point first though myself.if i am wrong and its the second from back which would be no 3 bottom,problem is likely its just not scouring good yet.two dont look too pretty in that regard in some pictures.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
