I made my own: A 1/2 horse motor, a used oil burner pump, but any small hydraulic pump will work. 2 woodsplitter type filter heads,one before the pump, to protect it, one after the pump, to further clean the oil, some tubing, hose fittings The pre-pump filter is going to pick up the most dirt, so change it twice as often. I used ZINGA filter heads, that have an adjustable bypass spring, and set it to the highest setting, as you don't want anything to bypass. I put a 60 psi pressure gauge in the system...when pressure starts to rise it's time to change filter cans. REMEMBER !, borrowing anything from a neighbor, and plugging it into your tractor quick couplers means you've transfered the contamination from his system...water, dirt, metallic particles,into your system
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
