Posted by John T on November 05, 2011 at 11:03:10 from (173.243.181.15):
In Reply to: Boosting a tractor posted by farmer boy on November 05, 2011 at 10:44:03:
Welllllllllll any battery jumping isnt the safest thing in the world ya know and yes Ive used 2 batteries before, but if you follow a few safety procedures you will liklely live another day.
1) Its ALWAYS Pos to Pos and Neg to Neg with respect to the battery posts regardless if some huge hunk of iron is bonded to one or the other battery terminals
2) Its best NOT to be making the last connection near the top of any battery because thats where explosive gases might accumulate and making or breaking connections usually makes a spark and that can ignite explosive gas which just might splash acid on you or your eyes.
3) If you first jump say the pos of one battery to the positive of the other (talkin both vehicles Neg grounded here) but then make the last connections on the frame or frames away from the battery (on or near starter is a good place) thats safer then making the last connections on the battery as warned above.
4) CAUTION many old tractors are Pos ground but its still rule No 1 above i.e. Pos to Pos Neg to Neg as far as the batteries are concerned. If you were to use a neg grounded truck to jump a pos grounded tarctor you still use rule 1, but I wouldnt want the truck and tractor frames to come in contact with each other.
5) Dont use a 12 volt battery to jump a 6 volt battery.
6) On many tractors its possible to just jump energize the starter motor without having to jump the tractor battery ya know!!!!!!!!!
CLOSING, did I mention Pos to Pos, neg to neg, and did I mention dont make the last connection near the top of any battery???????????????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.