There is actually, creeper with steel wheels and a sloped concrete floor LOL ! Well, I've dealt with it here as needed, not all that bad, just the fact that you are on your back, and if it was easy in your 20's, to move around, get leverage, able to put some effort on what it is you are working on, not so much now, working off a creeper or on ones back is an undignified slap in the face as you get older ! I prefer a thick piece of cardboard, over a sheet of plywood when necessary, or plywood and creeper, when outside.
The sad thing is I own a 6000 lb Mohawk lift, and have yet to finish a place for it to reside, thing looks at me while I crawl under a vehicle, one of these days darn it ....... :)
There is something to those semi soft type casters. I used to work for a curtain wall company, we installed the metal and glass panels you see on these giant high rise buildings. The company I worked with is doing the world trade center, there was a special on history channel about there portion of that job and how the do it. There is relevance here, stay tuned .....
To get those panels to the job and staged on the floors, they are crated up, hoisted to the floors and placed on............ furniture dollies with a specific type of caster, somewhat soft, but not too much. The crates are easily moved to the work area, panels rigged to be installed, we bought stacks of these dollies, those particular casters are the only type that work on a job site with concrete floors that my be rough or have things scattered about, those dollies roll over things because they give, a hard or steel caster, forget it. I had a large curtainwall job assigned to me, I went to CA., (new MGM H.Q. building going up in Century City) to review what they were doing and plan my job accordingly, the first thing I learned was about those dollies.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
