Well I took the advice and got my experienced friend Fred"s hhelp. Went up about 25 ft and wrapped piece of change around it. Hooked up 2 sections of 20 ft cable to that. Ran chain around very large stump 90 degrees to right about 50 0lus feet away and put tension on it with come along. With that line tight it was above my head. I was far enough away so I hung on that. Fred notched it and then back cut it leaving a good hinge. I pulled down on the line and it came down right where Fred said it would. It even rolled off the tree it was hanging on just like Fred said it would. Fred grew up on a farm here in Maine. After it went down he had a big smile and said "that felt good!". With out Fred I would have notched it and used my 2 come alongs to pull it sideways to get it fall. I had concluded hitting it directly with the loader or having the tractor near it was not a good idea. Tks for all the advice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
