Posted by jackinok on November 29, 2011 at 11:35:53 from (162.58.82.136):
In Reply to: Culvert installation posted by JD Farmer on November 29, 2011 at 10:33:17:
I kind of agree with billy here,its hard to say. MY rule of thumb is if i think a 24" will handle it i put in a minimum of a 36" or more. Theoretically you dont want any running over the road. Theres just no predicting what will happen. If theres some doubt as to what size to get,try getting in touch with you local wcs,or scs people. They should be able to put you in touch with their local engineer who calculates these things. It allways surprises me as to how large they recommend. Just fyi,check around you and see if there is anyone making precast concrete pipe near by. Here at least they will give you the ones that have a slight defect,and thats what i use. they are tough to move around and work with but the make a really good culvert. And another tip,DO NOT pack the tin horn in with rock or gravel,water will run right through it and make it wash more. proper way is to pack it in good with plain clean dirt or clay. Then just add enough rock on ends to slow water hitting the ends of pipe. Loose rock wing dams on ends "should" be five times the width at base than the height. They stay in place by weight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
