Posted by JDseller on December 03, 2011 at 19:27:37 from (208.126.196.144):
In Reply to: impact driver bits?? posted by dave2 on December 03, 2011 at 16:52:51:
You are finding out why there are impact driver bits just like impact sockets. These newer impact drivers are getting real powerful. The regular bits are not made to take the sudden force an impact driver puts on them. They are designed for straight torque. You should not use regular bits in an impact driver. They can shatter and cause bodily harm, not joking.
My oldest son got an impact driver for a gift two years ago. He just used his regular Dewalt bits. He was using the torx bit to drive four inch screws into seasoned pine lumber. It shattered. A big piece of it went into his left hand. It cut a ligament to his middle finger. He had to have several surgeries on his hand. It still gives him problems.
I made all of my kids get the correct bits for the correct tool. We got together and ordered them from Granger's. We spray paint the impact bits red. That way we know if we have the right ones in the impact drivers.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
