Posted by Dust Off on December 04, 2011 at 18:01:33 from (207.224.104.231):
In Reply to: OT: what to do? posted by farmallman on December 04, 2011 at 16:47:36:
The same thing happened at work over a long, three-day weekend, but they did manage to get away with some valuable equipment. This building has large overhead doors at each end and one heavy pedestrian door. The trouble is....if they get in (they cut a hole in the wall), they can open the overheads from inside and drive the stolen eguipment out. In addition to the usual motion lights, we did three things to see that it didn't happen again.
1. Chained the overhead doors from inside with hardened chains and padlocks.
2. Designed and installed a 6 volt alarm circuit on the doors that uses the momentary contact principle (using hidden limit sw. on the doors). It has a battery backup in case they get cute and shut off the power). We can disable it using a well-hidden switch when we enter. If the door is opened, even a little, the siren, which is located outside under the eaves in a cage....literally SCREAMS ...can be heard for 3/4 mile, easily. Everything for this alarm circuit was less than $150. Remember, the battery backup needs to have a charging feature to the circuit.
3. I can't tell you what the third thing is. It's a secret....but legal.
I know the frustration associated with this type of breakin and I wish you luck in solving it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
