Billy sometimes you don't know the whole story....Try operating three years in the red, no insurance, while your teeth literally fall apart because of side effects of certain prescribed drugs. Went to the dentist to get releif when the pain was too much but to fix everything the estimates started at $26,000 and went up.
Now after a couple of semi profitable years the only option left is dentures, not something I look forward to but, slowly the bad ones are getting pulled one by one. Eventually I will have to get them.
Denture mills advertise extractions at $39 a tooth... when you do them all at once..That is just not an option for me....too much pain and not healthy according to several dentists I have seen..I have had teeth pulled for around 85-150 a tooth...but have had some hi faluting places want over $300 a tooth to simply pull one. Let's see....26 times $300?? $8000 just to pull out teeth???Flat out Robbery in my book.
I cannot imagine trying to get your teeth fixed making minimum wage working at Wallyworld.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
