5020s rock; i could not agree with you more, wish i had his address as well. he is spinning his wheels doing what he is doing. i'm sure there must be a few like minded people in his community that agree with him but are afraid to put anything on the line to back him. he needs to talk to someone like fred kelly grant in idaho , a property rights lawyer. fred is helping us here in siskiyou county. incidently fred was instrumental in preventing the super highway from being built from mexico to canada a few years back. it would have decimated thousands of acres of prime ag land and cut right through the middle of several towns. the kicker was, the road and a lot of land on either side of it would have been owned lock stock and barrel by a very wealthy family in either spain or france. all revenues generated ie motels, gas stations, etc. would have gone to them, not anyone in our country. fred tutored three small town mayors in texas re the process of coordination. story in short they sent the feds packing. as a side comment, our primary candidate mr. perry was for this un american nonsense and did not lift a hand to help the small town mayors. also during a debate it was brought up that he had signed a bill into law that little kids down to the age of twelve could opt for a vaccination against stds without their parents knowledge. he later admitted this was a mistake. why am i saying this? i don't have an ax to grind with mr. perry, fact is i wouldn't vote for any of them running right now, i am just pointing out again this man is polished, well groomed, well educated and his GRAMMER almost perfect plus his signage probably flawless. you have to research the track record of these people or hang with people who do. if we don't we are for sure going to lose our republic. and our freedoms. hope i haven't offended anyone, well ......maybe i should have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
