Posted by farmer boy on December 25, 2011 at 14:23:27 from (66.209.54.106):
I asked about a 4l60e a while ago that wouldn't unlock the tcc solenoid. It would unlock/lock properly after pulling the trailer 10-15 miles. I replaced the tcc solenoid and it turned out to be the problem. Is it possible that the tcc solenoid was 'tired' and the warmer fluid allowed it to work properly. Right now the truck has a 11"x16" cooler on it without cold fluid bypass. If this is possible, will it hurt the tranny in other ways? ) Also, right now the truck occasionally has a slight slip, under heavy load at heavy throttle in 2nd when hot(so the slip doesn't happen very often) 4th gear has never had a problem. I have read quite a bit about a corvette servo(stock from chevy, not aftermarket) and from what I understand, it will make faster shifts, and increase hold pressure, which sounds like a win win to me. I tow in D not OD, so I'm not so scared of killing OD. All knowledge is greatly appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.