Posted by 37Chief on December 26, 2011 at 19:34:43 from (68.8.206.100):
In Reply to: chimney flue sizing posted by bkpigs on December 26, 2011 at 18:47:29:
I have a antique wood burning stove called a Round Oak. my stove had a 7 inch oval opening. I got a 7 inch oval to 6inch round adapter, then contunued with 6 inch. I have single wall stove pipe in the room, but where it goes through the wall I have double wall pipe. I think it is clled metal bestos. My stove pipe has two 90 degree ells, and works fine. I have been using it for 25 or so years. I would think your stove will be fine with the 6 inch pipe. Make sure you have enough clearance between the stove and the wall. I put my stove too close to the wall, and the bricks get very hot behind the stove. I had to lay a piece of sheet metal next to the brick wall, to keep the wall cool. Just my two cents worth of info. Stan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.