Posted by John T on January 02, 2012 at 07:05:39 from (67.208.197.124):
In Reply to: Electrionic ignition posted by CumminsMan on January 01, 2012 at 17:19:19:
This is one of those questions that yields plenty of opinions but there are some engineering basics involved so it its your decision to change over to an elec ignition or not. The elec switch has advantages as well as disadvantages as follows:
1) An elec switch does provide a fast positive current switch as opposed to mechanical points which bounce and ring and the contacts burn and pit and carbon up and develop resistance and voltage drop.
2) HOWEVER if points fail you can often file them and get back to the shop while if an elec switch fails youre pretty well stranded.
3) An elec switch costs more but often once it burns in many can last for years versus having to buy many sets of points and/or condensors.
4) HOWEVER if you pay like $100 for a system and it fails soon you would have been better off buying several sets of points over the years.
5) Many owners report improved starting and low idling characteristics using an elec ignition
6) HOWEVER some report problems when a tractors starter reduces battery volatge drastically
7) I doubt you will achieve any (maybe none) noticeable HP increase using an elc ignition versus a good set of points
8) HOWEVER as long as it works properly (maybe a short itme maybe yearsssssssss) the elec switch will provide relative consistent performance while a set of points will over time burn and pit and carbon and decrease performance as time passes.
NOTE to get the most bang for the buck and utilize more of the advanatges an elec switch has to offer I suggest you match it with a high energy coil and then you get a higher energy spark discharge versus that a stock points ingition delivers.
A good set of points properly adjusted and maintained will provide long service at a relative low cost while an eelc ignition with a high energy coil can yield more spark energy AS LONG AS IT IS WORKING
SUMMARY so there are some engineering considerations so now its your choice
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.