I don't find the "you get what you pay for" to be true with guitars. At least not with playability. Old guitars are like old tractors. Some sell for a fortune even if they don't work all that well as compared to some newer stuff. Now - the sound of old electric pickups and tube amps is another issue - but that's not what you're asking about.
My dad had his own country-western band from the 1940s to the 1970s. He had two vices that I know of. Drinking beer and buying guitars. When he died he had over 50. I've got some of them. Back in the late 60s, he was given a $50 new Yamaha acoustic and loved it. He was amazed at the sound for a "cheap" guitar. I still have it and it still plays fine. It plays easier then his old Gibsons and Gretschs guitars which are worth a lot of money. I recently played a new Yamaha F336 and it plays even easier then my old one. Lower action which is nice for a beginner.
You can spend $20,000 or $50 and still might get a hard player.
You need to decide if you want electric or acoustic and work from there. An acoustic usually has bigger and higher strings that makes it play harder - especially with a new player trying to master bar-chords. But you CAN put smaller strings on it. It will lose sound quality but play easier. You can buy a new Yamaha F335 for around $150. That would be my choice if my little kid wanted to learn on a acoustic.
If you want electric - you can buy a new Fender Squire with a cheap amp for $200 total. These cheap (usually Mexican) Fenders play very well.
I find some of these new cheap guitars to be kind of annoying because some play so well. Similar to a new $150 Savage 30-06 rifle I bought recently that out-shoots my pre-64 Model 70 Winchester. The Winchester is much nicer to hold and look at though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
