Posted by gun guru on January 08, 2012 at 03:18:34 from (75.128.139.102):
In Reply to: Office pay vs shop pay? posted by sunny 5 acres on January 08, 2012 at 02:22:48:
Appearances can be deceiving. I have a small shop office. I am also running a Bridgeport milling machine 50% of the time, and in the office ordering material and finished machined details from other shops. Every week I have to write my boss an itemized status report for each job that goes through the machine shop, get multiple quotes for each detail that is being quoted, keep an Excel spreadsheeet log for each job. BTW: each job is a machine with a fixture, hardware, machine guarding, tooling, etc. I have 3 machinists that get orders from me. All they have to do is run their milling machine or Lathe and do the work and follow the print, I have to run a mill also and do all the other work. As the saying goes, the more you can do the more responsibility you will receive. Working in the front office is sometimes much more stressful because the owner is 30 feet from you. I am 200 feet from the owner and separated by cinder block walls, not cubical walls.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
