I bought a new mower in October. I cut commercially on the side for a 2nd job. I did a lot of research before I bought one. I traded a 721D Grasshopper with a model 16 collection system on it. For a home owner this would be a good mower. I had a lot of problems with getting parts and they are too slow for commercial use. My dad bought a 737 Deere new several years back. It has 1800 hours on it. Hands down best mower made. You figure when you have rep. from other companies that tell you that was the best mower made and they aren't selling that brand it has to be good! If you could find a low houred used one thats the route to go. I couldn't find one close when I was looking or i would own one now. Exmark is a good quaility mower but slow. Dixie has too many problems with decks and wheel motor/pumps. I ran a Kubota and it was a good machine also i thought but too heavy and awould not stick on a hill for nothing. Ferris is way over priced for what they are and are not reliable in the way they cut. For me on a new mower it came down to a Scag or Hustler. I really liked both of them. I ended up with a 2012 Hustler Super Z 31HP Kawi. 60" deck. The new hydru. system on the Hustler is great! It cuts great, is not terrible on fuel, will stick on a hill as good as our Deere, it is not the best riding but still not bad. If you want a wide selection and a good guy to do bussiness with I can tell you I bought mine at Southern Indiana Equip. Like someone else said stay away from anything MTD and you will be money and time ahead that much more! Hope this helps.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
