In NC you have to tag the vehicle for the weight of both the vehicle and any load you might haul or tow. In my case the GVW on my truck is 26,000 and I can legally haul a trailer with a GVW of 10,000 or less without getting a CDL. Basically then I have to tag at 38,000 to make sure I also give myself a little buffer zone to insure I don't go over my tagged weight. Thing is in the tweove years I've had my truck I've only put a trailer behind it maybe half a dozen times.
If I hauled a trailer all the time it wouldn't be a big deal, but I don't. Even then I'm not complaining about having to pay for the right to haul the trailer when I want, it just galls me to see others getting away with doing something illegal and it costing them nothing simply because weight wise they "aren't as illegal" as I would be doing the same thing with my truck and trailer. In other words if they are going to enforce the laws then enforce them across the board and not just on heavy commercial vehicles. Thing is they aren't going to do that because many of the fines, etc for violations are based on weight and a 40,000 lb plus truck is going to bring in more money than ten of the 4,000 lb trucks.....and what DMV officer is going to actually work that hard to make sure they get the quantity of stops and fines they need to keep the politicians happy????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
