There is also another breaker a the generator that is thrown when starting the generator. this generator was installed and totally hard wired into the farm when I bought it. and for your info I had a Fortis lineman here doing repair work and ask him to look it over. As I was concerned about power running back from my generator onto the system when running and he advised that I switch off both this breaker and the one at the generator and since it could well be his life on the line i think I will take his advise over yours. Thank you for your input and no disrespect but what makes you so self righteous and knowledgeable?
Rocko.
Unless the generator and utility transformer breaker are mechanically and/or electrically interlocked. Your setup is technically wrong, illegal, breaks the NEC code and is dangerous to man and machine.
So just what exactly are your qualifications? Asking Bubba the lineman for a quick look? I was watching the "Dirty Jobs" episode where they are replacing a broken pole in Wyoming. Raised some eyebrows when one of the line man said " the lower neutral wire just carries unused power back to the generating station......................"
My electrical qualifications and real world in the field experience far far exceed yours, don't worry about that. 35 years of full and part time school with continuous updates. 309A Interprovincial trade ticket. And several pages just list the individual qualifications in Nuclear instrument, electronic, control and power both low and high voltage. Fire Fighter Captain in a nuc plant for 10 years too. Want to know something else. There is still more to learn after all this time and experience. I also use spell check to correct most of my grammar and spelling mistakes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
