Posted by John T on January 16, 2012 at 06:34:03 from (71.52.112.80):
In Reply to: welding and electrical posted by notjustair on January 15, 2012 at 20:31:10:
It makes me nervous also when automotive computers are concerned. Youre working with voltages HIGHER then those normally used in the auto electrical system,,,,,,,, youre passing wayyyyyy more current through certain parts,,,,,,,,sensitive electronics arent real fond of voltage or current spikes etc,,,,,,,,,,currtent will seek all available paths (perhaps via an electronic component)
SO IF I WAS GOING TO WELD ON A LATE MODEL CAR ID TAKE ALL NECESSARY PRECAUTIONS (disconnecting battery and computers etc as recommended)
BUT if others dont care to do that its their car amd money and their risk NOT mine but in good faith and conscience I just have to recommend following the manufacturers aDVICE over opinions posted here, including mine, now you and others are free to do as you like.......
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
