In Southern Indiana it will need some type of auxiliary heat, whether it be electric heat strips, propane/NG furnace, or some type of boiler. 90% of the heat pump systems use the electric heat strip method. The "Hybrid" propane furnace option hasn't been around for very long and cost me about $400 more to install than the heat strips "electric furnace" when I was building my house. I use anywhere between 200-400 gallons of propane a winter. Regardless, if a heat pump is installed, it will have some type of auxiliary "Emergency" heat source. I have my "Emergency" heat set to switch at 35 degrees outdoor temperature. Heat pumps are really only efficient to the mid-upper 30's. It will also automatically switch from heat pump to propane if the household temperature gets more than 3 degrees different than the thermostat setting. I highly recommend the Honeywell touchscreen thermostats with outdoor air temperature sensor if you do this.
I worked on a farm for a guy that had an outdoor woodburner unit. He owned a pallet mill, so he burned wood blocks. My job was to feed the beast in the afternoon. It uses a ton of wood, but it is cheap. Others I know have pulp wood delivered to them from a logger. I was thinking of getting this type unit only because I want to be able to heat my 30x40 shop cheaper than installing a propane heater that hangs from the ceiling. I have plenty of fallin trees to cut, I just hate cutting it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
