Posted by French Garden on January 22, 2012 at 23:52:08 from (71.198.30.126):
I'm reworking an 8n and trying to find out how to determine whether my pistons are worn enough to need replacing or I can get away with a ring job and a valve job. (How much piston to sleeve gap is OK?)
Before I tore it down, it had poor compression (I didn't measure this, but could tell from the poor performance) and was burning a lot of oil, but the intake valve guides were clearly the source of a lot of the oil (the intake ports were covered with oil and the valves had a lot of slop in the guides) and it was in bad need of a valve job so the compression issue was clearly not all ring related.
The sleeves do not have much of a ridge in them and look pretty clean overall I have not pulled the pistons yet (will do so tomorrow.) I can mic the sleeves and pistons if need be, but do not know the specs for this or whether one can just put a feeler between the piston and sleeve to determine the wear.
It also had very low oil pressure so may need bearings and an oil pump.
I don't use this tractor a lot (I have 7 others and use this one for spreading compost only), so just getting it running better will probably get me to the end of my farming days.
Thanks to anyone who can help. I'm not an experienced mechanic, but old enough to ask questions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.