Posted by TonyIN on January 23, 2012 at 12:40:45 from (74.215.182.169):
In Reply to: ot;handicap access posted by jackinok on January 23, 2012 at 08:23:09:
Couple other thoughts... As you go through each area to renovate - install 1/2" plywood backer behind the walls. I like to do that in bathrooms and bedrooms when renovating for an older couple. ADA gives you the approved locations (and I follow them), but nothing wrong with having a 4x8 sheet of plywood under the drywall. Then you can mount what you want, where it works best for her. And move it later as needs change. Also - look into some minor modifications to a normal bath vanity cabinet. Depending on how yours is constructed, its size, and your carpentry skills, you can make the toe kick swing out with the cabinet door and still leave room under it for a shallow shelf or two. It also helps make the place look a bit more residential which may make for a better mental transition for her. You can do the same with the kitchen sink area. Also, with a little plywood, 2x8 and remedial carpentry, you can depress the subfloor in the shower by cutting out the top part of the joists and reinforcing them with the material (check with someone knowledgeable first!). this can give her a roll-in shower if she wants. Following ADA is a good idea and as mentioned by others, will help. Keep in mind it is a code that was generated to benefit as many as possible and may not be the best fit for your situation. Last, the more you can do for her on her other daily activities, the better her transition will be. Little things like lowering a window for better views, making it easier for her to do what she did before, etc. will leave her feeling less confined. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
