Posted by downsouth on January 24, 2012 at 18:09:18 from (205.188.116.74):
Since your thread quickly migrated to the next page, I thought I would open it up again.
You got some useful and some useless information which is normal, so you have to read between the lines.
I can't recommend a breed for you, but there is lots of information on the net. We raise Boers (meat goats) and they are very easy to take care of, and the kids sell pretty easy here near the Mexico border. As for feeding corn, yes you can but keep it to a minimum. They can eat just about any pellet feed that cows or horses eat, and that is cheaper than corn now. 12% protein works well for me. They will also need hay, and they will eat the cheapest hay around. They are not real picky. As someone else said, the hay needs to be in a feeder as they will waste a lot of it. If they are penned, be sure and have a good fence. Even on pasture you need good fence, goats tend to think everything on the other side is better. As someone else said they will rub along the fence and bring it down if not secure. The picture below is of a 16' section of panel, and I have to straighten it back up now and then. I have a big buck that thinks it's his personal rubbing wire and part of the time his battering ram.
And always keep some extra fence handy just in case.....
I took these pictures this evening at feeding time. This is one of my bucks with a few of his ladies.
And a few of the kids letting me know it's time to eat and that I need to quit taking pictures.
And this little guy thought the camera might be a treat. (They get cattle cubes for treats)
And now it's chow time for the kids. (about half the kids were pulled off their mommas a week ago)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
