Posted by Owen Aaland on January 28, 2012 at 17:35:22 from (216.47.35.22):
Engine rotational direction is determined by looking at the engine from the front of the tractor. You engine turns clockwise.
Starter rotational direction is determined by looking at the starter from the drive end. In your case, since the starter installs from the back of the flywheel, it need to rotate counter clockwise to turn the engine clockwise.
The original starter number was probably 1108041 if it was a 6 volt system or 1108173 if it was 12 volt. In either case the drive number is 1868804. That is a 10 tooth CCW drive.
You may also run across a 9 tooth drive used in those starters. They were sold mostly for Ms and 400/450s to give a little starter power.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Using Your Tractor: Creating a Seed Bed - by Chris Pratt. When I bought my first old tractor, I had only one idea in mind. It wasn't the preservation of old iron since at that time, I was unaware that people even did this. It wasn't to show off my restoration skills (though I had tried my hand at a couple of old motorcycles in my teens and if I recall correctly, those old motorcycles were sold in boxes about one quarter finished). It wasn't to relive memories of Grampa, Dad or myself out on the back 40 nursing the Farmall pulling too many b
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
