Thanks for the responses so far. The drill is John Henry drill which, in this case, is a drill boom mounted on a PC160 Komatsu excavator with a compressor setup taking the place of the counterweight on the rear. Because of this the compresor engine is setting a fair distance from the drill itself, even when drilling with the boom sucked in. Usually though the drilling is done with the boom setting about half extended just to keep as much flying debris from hitting the cab.
That said the engine is a diesel with an open draft tube straight off the top of the valve cover. It was not blocked, that was one of the first things I checked. There is no plausible way to hold pressure inside the engine in any way, shape, form, or fashion that I can come up with. Too the end of the draft tube is hanging in mid air and is located in an area where it wouldn't be accessible for someone to get to to manually block off.....especially with the engine running. Like I said the dipstick should have blown out before the valve cover went but it hadn't moved.
As far as something hitting it, the engine is located in an enclosed compartment located at the rear of the machine. The way it sits the majority of the part of the valve cover that broke is covered by a solid sheet of metal located about 3 inches above it. The metal sheet is rigid and can't move so there is no possibility that itshifted and did the damage. The rest is covered by the hatch which, again is solid but sets about 14 inches above it. The way the air to the aftercooler is piped across the part not covered at 3 inches leaves one spot less than 3 inshes wide for a foot, etc to hit it, and another spot maybe 5 inches long for something to hit it. Funny thing the exposed spots aren't where it broke. Beyond something flying up out of the hole, back 20 plus feet, and then reversing direction and heading forward into one of the cutouts on the housing, nothing can get inside. In other words a piece of rock big enough to do any damage is an impossibility.
So, good thinking so far based on just what info I gave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.