Posted by rustred on February 02, 2012 at 20:36:26 from (74.200.18.156):
In Reply to: SUPER C ENGINE KNOCK posted by james johnston on February 02, 2012 at 20:03:45:
depends on what you mean by slight movement, if you can move it its toast. not talking side ways either, as you will have side ways movement. do what you gotta do cause the sooner you get that knock outa there the better you are, if its not too late allready. crank will have damage and be egged and just a new brg. might not last anyhow. and once you have it apart check the other rods also with plastigage. after your repair job run straight 40 oil or 20-50 oil in it. check your oil pressure with a master guage also , before and after. and when you go to sell it tell the customer the btm. end story, so when he hooks on the plow and the rod flys threw the block he knows why.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
