Posted by JDseller on February 04, 2012 at 21:49:28 from (208.126.196.144):
In Reply to: bad tractor day posted by HoosierHog on February 04, 2012 at 17:59:38:
That 3 cylinder non sleeved motor is an easy one to freeze and break. I have had several over the years that would get water down the muffler then freeze and break the block. I usually have a local machine shop bore the block and install a sleeve in the bad cylinder. I have the two good ones bored to +.030 or .060 then match the replacement sleeve to them. Install an overhaul kit and you are good to go.
It does not take much rain either. I had one that was used on a Friday and left out side. We had one inch of rain Saturday. It got to -5 Monday. The owner started it Tuesday morning. Cracked number three cylinder wall and dropped the water into the oil. So it only took 3-4 days to wipe out the motor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
