Posted by Fritz Maurer on February 06, 2012 at 16:50:37 from (216.137.136.168):
In Reply to: Case LA Clutch posted by Jamie jackson on February 05, 2012 at 18:09:02:
I don't really know about Case LAs , but if you look in the access hole, you should see a threaded device of some sort for adjusting the clutch. It may be a small threaded sleeve behind the throw-out bearing, or a large threaded ring next to the flywheel, with holes or notches around the perimeter for locking purposes. The thing that can make a over-center clutch stiff to operate, is if the throw-out bearing slides on a sleeve, the dead grease can get gummy and sticky. This is assuming that the linkage isn't damaged or frozen, and that the fork freely rotates in the clutch cover or bell housing. Get a can of Blaster and hose down the area around the throw-out bearing. The clutch lining is too far away to get penetrant on it, don't worry about that. The best advice I can give you is start by finding an I.T. manual for you tractor. One tip that may help is that be prepared to adjust the clutch more than once in the same day. This is because when you start banging away at the adjustment, all that clutch dust neatly stored in the flywheel is going to fall down between the clutch plates and make the clutch adjustment feel tighter than it really is. The book will give pounds of effort required to engage the clutch, but I like to set them up just enough so it clicks in easy. If you pull a plow and it slips, go one more notch. Don't get carried away. Excessive engagement pressure is hard on the throw-out bearing and makes the machine harder to operate.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.