Posted by david - OR on February 08, 2012 at 17:04:11 from (208.67.204.213):
In Reply to: Pulling Stumps posted by SouthernFarmall on February 08, 2012 at 16:32:41:
The tire tread pattern is designed to pull better with the tractor going forwards. The weight transfer as you pull forward will work in your favor rather than against you pulling backward. If you keep the tractor in the lowest gear, pull from the drawbar and not from the top link (or other unapproved part of the tractor), and take up the slack slowly (rather than trying to yank it out) the flip-over potential is small and controllable.
4 to 10 inch diameter stumps are not easy to pull out with an ordinary farm tractor, especially if they are only a foot or two high. It's better to leave more of the tree and pull from up high on the tree.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.