Posted by AG in IN on February 15, 2012 at 07:52:30 from (67.236.73.44):
In Reply to: Plow Bolt questions posted by kyplowboy on February 15, 2012 at 07:22:25:
Dodgeit said: (quoted from post at 16:22:25 02/15/12) I have what appears to be a #7 plow bolt, sometimes known as a bucket tooth bolt. The problem is that in looking up replacements they all start larger sized than I am needing. I need 3/8 x 1 1/4 and 7/16 x 1 1/4.
They came off a Deere 472 disc plow, and the old parts #s have been replaced by #3 plow bolts.
Any ideas where to find them? I need 10 of the 7/16ths bolts and 4 of the 3/8ths size.
Thanks
McMaster, Grainger, and Fastenal have the larger sizes, usually 1/2 inch diameters and larger in grade 8.
The Parts Depot would probably have some, but you'd need to know OEM part numbers (IH, JD, Oliver, MH, and others used these) and find a dealer who orders from them.
There are other places that will supply these in the size, grade, and head type you desire, but you're looking at a custom order of thousands or 10's of thousands of a single size of bolt.
AG
This post was edited by AG in IN at 07:54:27 02/15/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
